AABCOOLING Thermal Grease 3 - 10g
- The most efficient thermal conductive paste with a conductivity of up to 8.5 W / mK, designed to provide the most stable operation. The modern formula TG 3 does not conduct electricity, so there is not even the slightest risk of electrical fault.
AABCOOLING Thermal Grease 3 - 10g is the most efficient thermal conductive paste with a conductivity of up to 8.5 W / mK, designed to provide the most stable operation. The modern formula TG 3 does not conduct electricity, so there is not even the slightest risk of electrical fault. Ideally fills the connections and the micro gap between the processor and the base of the cooling system (heatsink). High quality ensures stable operation without compromising thermal performance. The paste should be distributed very thinly for the best conductivity.
- Performance at the highest level of 8,5 W / mK
- Appropriate density and viscosity
- It does not dry out or effuse
- Easy to use and remove
- Operating range: -200 to 280 ° C
- Stable operation without deterioration of conductivity over time
- High thermal conductivity guarantees top performance.
- Proper density and viscosity ensure accurate placement during pressure.
- Dense consistency - does not dry, does not effuse.
- Stable operation without compromising conductivity over time.
- Simple application – you should distribute a very thin layer.
- Does not conduct electric current - does not cause short circuit on very sensitive electronic circuits.
- Wide working range from -200 to 280 degrees C
Application:
Systems used in PCs, laptops and other electronics:
CPUs (between the heat sink and the CPU), graphics cards (between the heat sink and the GPU), chipsets (between the heat sink and North Bridge and South Bridge), power sections and among other heating circuits in widely used electronics.
Comments:
Instructions for applying the paste to the system:
1. Remove the remains of the old paste using the included cloth soaked in isopropyl alcohol. Wait a moment for the preparation to evaporate after cleaning
2. Apply a thin layer of paste to the processor surface with the included spatula and spread evenly.
3. When installing and pressing the heatsink to the processor, gently rotate it to the right and left several times to perfectly distribute the paste between the processor and the heatsink base.
Included:
- 1 x AABCOOLING Thermal Grease 3 - 10g
- 1 x Cloth (60x60 mm) soaked in isopropyl alcohol
- 1 x Spatula/Spatula (length 80 mm)
